|
Share on:
|
|
|
Made the T-914 clip
I made the T-914 clip from a scrap piece of aluminum and drilled it for installation sharing one of the cap flange rivets. Here I'm checking the fit. The instructions don't really say how to make the clip. So I cut a 2-3 inch piece of sheet aluminum from the scrap bundle, a half inch side. After deburring the edges, I duct-taped one end of the scrap piece to the shank of a normal sized screw driver and bent the scrap piece around it. Then I compared my clip to the drawing and cut of the end of it to match the drawing.
|
|
