|
Share on:
|
|
|
Nutplate drilling time again
Now for some bending over exercises to drill the rivet holes for the nutplates between the F-742-L&R Aft Seat Floors. I can see why some builders use a rotisserie fuselage stand so they don't have to bend over so much. It's probably a good idea, but I'm going to stick with the bending over method. All I got done this evening was drilling these holes. Tomorrow I will rivet the hinge halves to the F-742-L&R Aft Seat Floors and then pop-rivet the floor sheets to the floor ribs.
|
|
