|
Share on:
|
|
|
Made the angle supports
Here’s where a compound miter power saw is indeed a necessity. It makes cutting these 45 degree angles a breeze. I cut two 2x4’s, 23 inches long (outer edge to outer edge) for the 2 bottom angle braces, and one 2x4, 25 inches long (outer edge to outer edge) for the top angle brace. Then it was just a matter of screwing it all together with my electric drill, with a Phillips screw driver bit. I used my framing square to make sure that the plywood was lined up at a 90 degree to the main 2x4 support before screwing in the first bottom brace.
|
|
